VINCENT KICKSTART CRANKS
A free service. If the splines on your kicker are damaged, I will be happy to run one of my broaches through it. Pretty good
success so far. I tighten the pinch bolt so the broach will just pass through the hole, carefully aligning with the original splines.
If the hole has been drilled out or other unsuccessful repairs have been attempted, it won't work. After broaching, you will need to
remove the 3 splines on either side of the pinch bolt slot so the pinch bolt will do it's job. Otherwise the kicker slides off the shaft.
It's not magic but it allows you to use that old kicker a little while longer. For the lower 48 states, please enclose $30 (will return excess postage) for
return shipping and insurance. It doen't take long to do these so a quick turnaround. Email or call first (see my homepage).
KICKSTART CRANK SPLINES, please read: Kickstart Crank and G83 Splined Shafts.
All OEM Kickstart Cranks, Series A, B, C, D, and Singles,use the same spline configuration and size.
All OEM Kickstart Cranks will slide onto all OEM splined shafts.
All of my Kickstart Cranks, Series A, B, C, D, and Singles, will slide onto
OEM splined shafts.
I have come accross 2 newly made splined shafts that do not readily work with my Kickstart Cranks. I can fit the new shafts to my Kickstart Cranks but
I would need the shaft in hand.
The best thing would be to make sure your new shaft fits an OEM Kickstart Crank, either a spare or a borrowed unit. If it fits, then my new Kickstart Crank
will fit, also.
Working on Vincents is not for the impatient or the faint of heart.
F72/6 - KICKSTART FOOTPIECE (Right Hand)- $55
Cadmium plated, Later type. Raised F72/6, foundry mark.
Cast 4140 Chromoly steel, not machined stainless.
Heat Treated 4140 chromoly to Rockwell 40C.
Twins.
G77 - KICKSTART FOOTPIECE (Right Hand)- $55
Cadmium plated, Early B type. Raised G77, foundry mark.
For the very earliest version, weld end lip (4140 welds easily) and belt sand round.
Heat Treated 4140 chromoly to Rockwell 40C.
Twins.
PR50B/1 - Single Kickstarter with Twin Footpiece and hardware, chrome plated. $315, one left.
PR50-194X - Series "A" TWIN Kickstarter with Footpiece, cadmium plated. $180.
PR50-194X - Series "A" TWIN Kickstarter with Footpiece, chrome plated. $240.
Suitable for "A" Singles and some other pre-WW2 bikes with Burman gear boxes.
Heat Treated 4140 to Rockwell 40C.
PR50-195X-Mark 1 - Series "A" Kickstarter Footpiece. Non-Folding
Threaded 9/16" x 20 tpi.
Heat Treated 4140 to Rockwell 40C.